Setting up remote for TV stream

1. Press and hold the "OK" button on the Entone front panel for approx. five seconds. When releasing the "OK" button, the Entone front panel will display "RC REG". The Entone is now in remote registration mode.
2. Identify the remote control, which is labled with a number 1,2, or 3 on the battery cover plate.
3. Press and hold the  "STB" buttom on the remote for about 4 to 5 seconds. The "STB" button backlight LED will light.
4. Press the "STB" button once again. Both the "STB" and "AUX" button backlight LED will light to indicate that the remote control is in registration mode.
Press "1" to send the "Register remote control to decoder 1"
Press "2" to send the "Register remote control to decoder 2"
Press "3" to send the "Register remote control to decoder 3"
5. Decoder "1" set to TV channel "10"
Decorder "2" set to TV channel "23"
Decorder "3" set to TV channel "39"                                                              

 Setting up remote for power and volume

1. Power on the device and on the remote control, press the desired device key once. Then press and hold "SETUP" until the device key blinks twice, then release "SETUP".
2. Press the "POWER" key once and aim your remote at the device.
3. Press either the "CHANNEL UP" key or "CHANNEL DOWN" key to do device auto-scan.
4. In this search mode, the remote control will send IR codes frim the library in five second intervals. The device key will be on and blink every five seconds while in device scan mode.
5. If the device turns off, a working code has been found. Press "OK" once to lock in the code. The selected mode key will blink twice.
6. If all code sets of that device are exhausted in the search in the search and the "OK" is not pressed, the selected device key will fast blink 7 times and the search mode will be terminated.
7. If A code cant be found call tech support.

Button Descriptions