Finding the Gateway ID #

1. Press the MENU button or the Wrench on the front panel of the RG2400 or RG2200. The Gateway Menu screen will be displayed on your primary TV.
2. Use the down key on your remote control to move down to Remote Control Setup.
3. Press SELECT on your RG2400 or RG2200 on your remote control. The Remote Control Setup screen will been displayed.
4. Press PPV on your remote control. The screen lists the ID for the remote, identifies which TV this remote controls, and shows the Gateway ID.If the Gateway ID programmed into your remote control does not match the Gateway ID of the RG2400 or RG2200, the system prompts you to reset the Gateway ID.

Setting up Gateway ID #

1. Point remote at Gateway.
2. Press & hold the SELECT button, then the MUTE button. Hold both buttons down together until the LED button illuminates, then release both buttons.
3. Press & release the B key. The LED button temporarily turns off. Releasing the key causes the LED button to light up again. You can now set the correct Gateway ID.
4. Enter the three-digit code assigned to your RG. (i.e. 006)

Setting up Remote for TV Stream

1. Press & hold the SELECT button, then the MUTE button. Hold both buttons down together until the LED button illuminates, then release both buttons.
2. Press & release the A key. The LED button temporarily turns off. Releasing the key causes the LED button to light up again. You can now set the correct Remote Control ID
3. Enter the single-digit Remote Control ID (1 for stream 1, 2 for stream 2, 3 for stream 3.... 0 will set remote to IR)
Channel 3          Stream 1
Channel 7          Stream 2
Channel 13        Stream 3
4. The LED button will blink three times and go out. The new Remote Control ID is stored in the device.

Setting up remote for power and volume

1. Turn TV on.
2. Point remote at TV.
3. Press & hold the SELECT button, then the MUTE button. Hold both buttons down together until the LED button illuminates, then release both buttons.
4. Scroll up using the BLUE UP ARROW button until the TV turns off.
5. Press SELECT to lock in the TV code.
6. The LED button will blink three times and go out.