Finding the Gateway ID #

1. Press the MENU button or the Wrench on the front panel of the RG2400 or RG2200. The Gateway Menu screen will be displayed on your primary TV.
2. Use the down key on your remote control to move down to Remote Control Setup.
3. Press SELECT on your RG2400 or RG2200 on your remote control. The Remote Control Setup screen will been displayed.
4. Press PPV on your remote control. The screen lists the ID for the remote, identifies which TV this remote controls, and shows the Gateway ID.If the Gateway ID programmed into your remote control does not match the Gateway ID of the RG2400 or RG2200, the system prompts you to reset the Gateway ID.

Setting up Gateway ID #

1. Point remote at Gateway.
2. Press the LED button and hold it down until LED flashes rapidly (LED IS IN BUTTON).
3. Press the REC button. The LED stops blinking and stays on solid.
4. Press the B button and enter your three digit Gateway ID # (i.e. 006)
5. The red light in the LED button will blink rapidly when code is accepted.

Setting up remote for TV stream

1. Press the LED button and hold it down until the LED flashes rapidly (LED IS IN BUTTON).
2. Press the REC button. The LED stops blinking and stays on solid.
3. Press the A button and then the one-digit stream (1 for stream 1, 2 for stream 2, 3 for stream 3.... 0 will set remote to IR).
Channel 3    Stream 1
Channel 7    Stream 2
Channel 13  Stream 3
4. The red light in the LED button will blink rapidly when code is accepted.

Setting up remote for power and volume

1. Turn TV on.
2. Point remote at TV.
3. Press the LED button and hold it down until the LED flashes rapidly.
4. Press the REC button. The LED stops blinking and stays on solid.
5. Press the POWER button and release.
6. Scroll up with the BLUE UP ARROW until TV turns off.
7. Press the SELECT button to store the TV code.